Briteq BEAMSPOT1-TRIAC NW 운영 매뉴얼 - 페이지 5

{카테고리_이름} Briteq BEAMSPOT1-TRIAC NW에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Briteq BEAMSPOT1-TRIAC NW 8 페이지.

ENGLISH

DESCRIPTION:

1. MAINS INPUT: 1m power cord with standard CEE 7/7 mains plug.

2. MAINS FUSE: protects the unit in case of electrical problems, always use the prescribed fuse!

3. MANUAL DIMMER: used to dim the output manually.

4. FROST FILTERS: 2 filters (10° and 45°) are included to make the very narrow 4° beam wider. Use the

metal ring to fix one of these filters in front of the 4° lens.

5. HANGING BRACKET: with a knob on both sides to fasten the unit in the desired position. you can use

the hole in the center of the bracket to fix a hook or truss clamp.

6. SAFETY EYE: used to attach a safety cable when the unit is rigged, see paragraph "overhead rigging".

OVERHEAD RIGGING

Important: The installation must be carried out by qualified service personal only. Improper

installation can result in serious injuries and/or damage to property. Overhead rigging requires

extensive experience! Working load limits should be respected, certified installation materials should

be used, the installed device should be inspected regularly for safety.

 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging

and servicing.

 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The

fixture must be fixed at least 50cm from surrounding walls.

 The device should be installed out of reach of people and outside areas where persons may walk by or be

seated.

 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's

weight.

 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.

This secondary safety attachment should be installed in a way that no part of the installation can drop

more than 20cm if the main attachment fails.

 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!

 Don't cover any ventilation openings as this may result in overheating.

 The operator has to make sure that the safety-relating and machine-technical installations are approved by

an expert before using them for the first time. The installations should be inspected every year by a skilled

person to be sure that safety is still optimal.

BRITEQ

3/5

BEAMSPOT1-TRIAC NW (WW)

OPERATION MANUAL