Avantco UBB2448 사용자 설명서 - 페이지 5
{카테고리_이름} Avantco UBB2448에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco UBB2448 5 페이지. Back bar refrigerator
Avantco UBB2448에 대해서도 마찬가지입니다: 사용자 설명서 (6 페이지)
페이지 인쇄
Trouble Shooting
Compressor is Not Running
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Cabinet Temperature is too Warm
Thermostat is set too high.
Airflow is blocked.
Low refrigerant levels.
Door is slightly ajar.
Interior Light is Not Working
Poor switch connection.
Bulb is not connected.
Bulb has burned out.
Condensation is Collecting on the Cabinet and/or Floor
Gasket is not sealing properly.
Warranty Information
All Avantco Refrigeration units are backed by a 1 year parts and labor manufacturer's warranty,
with an additional 4 year warranty on the unit's compressor. For warranty inquiries or service,
first locate the serial number plate on the front of the unit, or inside the door jamb. Next, call
the 800 number located on the serial number plate. Be sure to have serial number available
when contacting service technicians.
This warranty does not apply to, and Avantco is not responsible for, any warranty claims made on
products sold or used outside of the United States.
User Manual
Replace fuse or reset circuit breaker.
Plug in power cord
Set thermostat to lower temperature.
Wait for defrost cycle to finish.
Set thermostat to lower temperature.
Re-arrange products to allow for proper air flow.
Make sure there is at least four inches of clearance
from the fan.
Contact a service technician to chek refrigerant levels.
Make sure door is completely closed.
Turn off light switch and turn it back on.
Make sure the bulb is correctly inserted in the socket.
Replace the bulb.
Clean, repair, or replace the gasket as necessary.
- 5 -