Berner ALC08 Series 설치 및 유지 관리 지침 매뉴얼 - 페이지 11
{카테고리_이름} Berner ALC08 Series에 대한 설치 및 유지 관리 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Berner ALC08 Series 16 페이지.
페이지 인쇄
- 1. Table of Contents
- 2. Uncrating
- 3. Wall Mounting
- 4. Suspended Mounting
- 5. Electrical Connections
- 6. Field Connections
- 7. Operating Instructions
- 7. Quick Start Operation
- 8. Maintenance and Cleaning
- 9. Service
- 10. Troubleshooting
- 11. Appendix
- 11. Serial Network Connection
- 11. Remote Mounted Display Faceplate
- 11. Infra-Red Remote Control
- 11. Bacnet-IP INTEGRATION
STEP ONE
STEP TWO
5 Standard Mode of Operation Options:
OFF
ON
AUTO
delu
PLUS
For heated units only
3 Customizable Mode of Operation Options:
See
www.berner.com/intelliswitch
(Section 5, Program Menu).
STEP THREE
To Start: Press the Down Arrow button once.
NOTE: To change from "Mode" to "Fan Speed" press the down arrow twice.
Use the Left and Right Arrows to scroll through the 8 available modes of operations
Door opens: The air curtain is off
Door shuts: The air curtain is off
Door opens: The air curtain activates
Door shuts: The air curtain continues to run
Door opens: The air curtain activates
Door shuts: The air curtain turns off
Door opens: The air curtain activates
Door shuts: The air curtain continues to run for a minimum of 60 seconds
Door opens: The air curtain and heater activate and run at set speed
Door shuts: The air curtain continues to run for a minimum of 60 seconds. If thermostat
is not satisfied, air curtain and heater continue to run until thermostat is satisfied. If
thermostat drops below set temperature, the heater and air curtain will run until
thermostat is satisfied.
for programming directions
Once the Mode of Operation is selected, press the"OK" button
Berner International
www.berner.com
111 Progress Ave. / New Castle / PA / 16101 / USA
800.245.4455
11