KitchenAid KDTM384ESS 사용자 설명서 - 페이지 4

{카테고리_이름} KitchenAid KDTM384ESS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KDTM384ESS 17 페이지.

페이지 인쇄

Add Rinse Aid

Your dishwasher is designed to use rinse aid for good drying

performance. Without rinse aid, your dishes and dishwasher interior

will have excessive moisture. The heating and drying options will

not perform as well without rinse aid.

Rinse aid keeps water from forming droplets that can dry as spots

or streaks. It also improves drying by allowing water to drain off of

dishes after final rinse.

To add rinse aid, open the dispenser lid by gently pushing in the

center of the lid with your thumb while lifting up on the edge.

Pour rinse aid into the opening until the indicator level shows that

it is full.

Close dispenser by pushing down gently on the lid.

This information covers several different models. Your dishwasher may not have all of the cycles and options described.

Dishwasher senses the soil amount and adjusts cycle times.

The most advanced and versatile cycle. ProWash™ cycle

senses the soil amount and toughness of soil to adjust the

cycle for improved performance using only the amount of

water and energy needed. Includes Heat Dry.

Use for hard-to-clean, heavily soiled pots, pans, casseroles,

and regular tableware. Includes Heat Dry.

This cycle, with only the Heat Dry option selected, and without

other options selected, is recommended to completely wash

and dry a full load of normally soiled dishes. The energy

usage label is based on this cycle and option combination.

Includes Heat Dry.

Use for lightly soiled items or china and crystal. Includes Heat

Dry.

When you need fast results, the Express Wash will clean

dishes using slightly more water and energy. Select the

ProDry™ option to speed drying times.

Use for rinsing dishes, glasses, and silverware that will not be

washed right away. Do not use detergent.

Full

Add

CYCLE GUIDE

CYCLES

NOTE: For most water conditions, the factory setting

will give good results.

If you are experiencing poor drying performance,

you may want to try a higher setting. Turn the arrow

adjuster to a higher setting to increase the amount

of rinse aid.

Select a Cycle (cycles vary by model)

Efficient dishwashers run longer to save water and energy, just as

driving a car slower saves on gas. Typical cycle time is approximately

2¹⁄₂ hours but can take less or more time to complete depending on

selections.

Select Options (options vary by model)

You can customize your cycles by pressing the options desired. If you

change your mind, press the option again to turn off the option. Not all

options are available for every cycle. If an invalid option is selected for a

given cycle, the lights will flash.

Start or Resume a Cycle

NOTE: Run hot water at sink nearest your dishwasher until water is hot.

Turn off water.

Push door firmly closed. The door latches automatically. Select the

wash cycle option and press START/RESUME or press START/

RESUME to repeat the same cycle and options used in the

previous wash cycle.

IMPORTANT: If anyone opens the door (such as, for adding a dish,

even during the Delay Hours option), the Start/Resume button must be

pressed each time.

Push door firmly closed within 3 seconds of pressing START/

RESUME. If door is not closed within 3 seconds, the Start button

light will flash, an audible tone will be heard, and cycle will not start.

SOIL LEVEL

Light to Heavy

Heavy/Baked-On

Light to Heavy

All soil levels

ESTIMATED WASH TIME*

(HH:MM)

MIN SOIL

MAX SOIL

LEVEL

2:31

3:16

2:59

3:59

2:22

3:27

2:22

3:27

:57

:62

:15

WATER

USAGE

GALLONS

(LITERS)

3.7-4.2

(14.0 - 15.9)

4.2 (15.9)

2.7 - 4.2

(10.2- 15.9)

2.7 - 4.2

(10.2 - 15.9)

5.2 (19.8)

2.1 (8.1)