2M Technology 2MTHWT-HMD 사용자 설명서 - 페이지 11

{카테고리_이름} 2M Technology 2MTHWT-HMD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 2M Technology 2MTHWT-HMD 20 페이지. Walkthrough metal detector
2M Technology 2MTHWT-HMD에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 빠른 매뉴얼 (12 페이지)

2M Technology 2MTHWT-HMD 사용자 설명서
2M Technolgy User Manual
Fig. 2
III. FUNCTIONAL PARAMETER SETTING
The parameters of the Walk-through Metal Detector (WTMD)
can be set according to the requirement. The parameter set-
ting is password protected and therefore the parameter setting
menu can only be shown after the password is input correctly.
Figure 6~13 shows the input password. The "SEL" is used
for selection password digits, while the "ADJ" is used to for
changing any selected digit. the "ENT" shall be pressed to
enter the password
.
The initial password of the parameter setting interface is
"1234", which can be changed by the user. The system has
been provided with a universal password of "1111", which is
always available. The user can enter the interface with this
password if the customized one is forgotten. After the user en-
ters the interface with the password of "1111", the customized
one will become "1234" automatically.
The password used for system setting is "1264" (for important
parameter settings), the user can enter the system setting
menu after this password is input.
The interface will show Fig.40 when an incorrect password
inputted. Input the correct password again at the password
interface.
11
www.2MTechnology.net