2M Technology 2MTHWT-HMD 사용자 설명서 - 페이지 7

{카테고리_이름} 2M Technology 2MTHWT-HMD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 2M Technology 2MTHWT-HMD 20 페이지. Walkthrough metal detector
2M Technology 2MTHWT-HMD에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 빠른 매뉴얼 (12 페이지)

페이지 인쇄

INSTALLATION SPECIFICATION

Installation instruction

1. Remove the packages of the main case and door plates.

2. Face the panel of the main case down, put the right and left door plates (as shown in the figure) at the specified

places and put the fitting box aside.

3. Put the right I left door plates and main case close to each other erectly and fix them together with 8 fixing

screws of the fitting box with an allen wrench.

4. Insert the DB25 plugs of the main case into the corresponding DB25 sockets of the right / left door

plates separately.

5. Insert the 3-pin plug of the external power cable of the fitting box into the socket being at the bottom of the

outside of the door plate (Note: The power supply is only connected when the socket used for the external power

cable and that used for the main case cable are set at the same door plate).

II. Directions for use

1. After the Walk-through Metal Detector (WTMD) is installed, keep pressing "RES" of the keyboard until the

machine is started and the panel lights up;

2. The started Walk-through Metal Detector (WTMD) will perform self-inspection and the item displayed on the

panel will change and twinkle. When the displayed item stops twinkling, both the number of passed persons and

alarms will be "O", meaning that the startup operation finishes.

Note: The Walk-through Metal Detector (WTMD) is available for customized settings based on different conditions and

requirements, see the "Operating specification" for the detailed setting.

www.2MTechnology.net

2M Technolgy User Manual