decorflame MP-2100 사용 설명서 - 페이지 6
{카테고리_이름} decorflame MP-2100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. decorflame MP-2100 7 페이지. Electric fireplace heater
decorflame MP-2100에 대해서도 마찬가지입니다: 사용 설명서 (7 페이지)
페이지 인쇄MAINTENANcE
maintenance warning
Disconnect power and unplug the power
cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow
at least 10 minutes between turning off the
unit and removing the light bulbs to avoid the
accidental burning of the skin.
risk of fire: do not exceed the
recommended bulb wattage.
rEplAcING THE
lIGHT BUlBS
Step 1: remove 12 screws on the back of
fireplace and open the rear cover.
There are 2 larger screws and 10
smaller screws.
Step 2: You will find 1 x 40W Type B-10 bulb
under log-set bed.
Step 3: loosen and remove the burnt out bulb
and replace with new bulb.
Step 4: close the rear cover. Secure the
2 larger screws into the top left
corner hole and bottom right corner
hole as shown in the diagram.
Secure the 10 smaller screws into
the remaining holes. Make sure the
screws are in the correct holes and
have been tightened.
Step 5: plug in the unit.
M A I N T E N A N c E
clEANING
To clean the unit, first turn off controls on unit
and unplug the unit from power source. To
clean glass display panel; remove dust with
clean dry cloth or to remove finger prints and
other marks clean glass with clean damp
cloth.
Do not use abrasive cleaners or spray liquids
on glass display panel surface. Metal and
metal painted parts should be cleaned with
damp cloth. Do not use abrasive cleaners or
spray liquids on these surfaces.
6