IKEA DISHWASHER 사용자 지침 - 페이지 7

{카테고리_이름} IKEA DISHWASHER에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA DISHWASHER 24 페이지.

페이지 인쇄

OPTION SELECTIONS

OPTIONS

DISH LOAD TYPES

Control Lock

To avoid unintended use of

your dishwasher, or cycle

and option changes during

a cycle.

IMPORTANT:

■

The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the

best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will

automatically compensate by adding time, heat and water as needed.

■

The very first wash cycle after installation in your home will be adjusted to include an additional 2 rinses. This cycle must not be

interrupted for proper sensor adjustment. If this adjustment cycle is canceled or stopped before the Clean light comes on at the end of

the cycle, the next wash cycle will repeat this sensor adjustment.

CONTROLS AND

CYCLE STATUS

CONTROL

PURPOSE

To start or resume a

wash cycle

To cancel wash

cycle

To follow the

progress of your

dishwasher cycle

Drying System

During drying, you can see steam escaping through the vent at the upper left corner of the door. This is normal as the heat

dries your dishes.

IMPORTANT: The vapor is hot. Do not touch the vent during the drying cycle.

DESCRIPTIONS

To turn on Lock, press and hold Heat Dry for at least

4 seconds.

To turn off Lock, press and hold Heat Dry for at least

4 seconds.

When Control Lock is lit, all buttons are disabled. If you press

any pad while your dishwasher is locked, the light flashes

3 times. The dishwasher door can be opened while the

controls are locked.

COMMENTS

If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator

flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.

Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher

drain completely.

The Clean indicator glows when a cycle is finished.

If you select the Sanitize option, when the Sanitize cycle is finished, the Sanitized indicator glows.

If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle.

This can happen if the cycle is interrupted, or the water could not be heated to the required

temperature. The light goes off when you open and close the door or press CANCEL.

USE WITH:

Anytime