IKEA DISKAD 사용 설명서 - 페이지 38
{카테고리_이름} IKEA DISKAD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA DISKAD 50 페이지.
IKEA DISKAD에 대해서도 마찬가지입니다: 매뉴얼 (36 페이지), 매뉴얼 (16 페이지), 매뉴얼 (45 페이지), 매뉴얼 (37 페이지)
페이지 인쇄
en Fault, what to do?
Fault
Fault code :
is lit.
Fault code :
is lit.
Fault code :
is lit.
A different fault code is
indicated on the digital
display.
( :
to :
)
p or
appears on the
digital display h. *
Refill indicator for salt @
and/or rinse aid H is lit.
Refill indicator for salt @
and/or rinse aid H is not
lit.
Water is left in the
appliance at the end of the
programme.
* depending on the configuration of your specific dishwasher
38
Reason
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
Not a fault!
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special
salt/rinse aid available.
Filter system or area under the
filters 1j is blocked.
Programme has not yet finished
Remedial action
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly.
pump" on page 36
Clean pump and lock cover correctly.
"Waste water pump" on page 36
No appliance fault, have the mains voltage
and electrical installation checked.
Switch off the appliance with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off water supply
and pull out the mains plug.
Call customer service and quote the fault
code.
See turboSpeed 20 min. in the chapter
"Overview of programmes". *
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter
"Water softening system/Special salt"
Page 13 or "Rinse aid"
Check refill indicator, levels.
Clean filters and area underneath.
Wait until programme ends or reset.
"Waste water
Page 15).