KitchenAid KUDD01DPPA0 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} KitchenAid KUDD01DPPA0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KUDD01DPPA0 16 페이지. Drawer dishwasher
페이지 인쇄
17, U se theside cutting pliers t ocutthecable tiesecuring the
hoses a ndpower supply c ord totheback ofthedishwasher.
back of
dishwasher
cable tie
18, Completely remove the power supply cord and save it, in
case a power cord installation is needed in the future.
Tip Over Hazard
Do not use dishwasher
drawer until inside cabinet
opening.
Doing so can result in serious
injury or cuts.
22, As the dishwasher is being pushed into the opening, slowly
pull the inlet hose and drain hoses through the utility hole. Let
the house wiring gather behind the dishwasher.
23, Remove the strap from upper drawer.
::,
If the cabinet opening is 24" wide x 34-1/2" high (61.0 cm x
87.6 cm), flexible trim pieces can be attached a!ong the top and
sides of the dishwasher. Top and side trim pieces are different
lengths.
1, Open the drawers to expose the chassis trim.
2, Center the flexible trim pieces.
side trim
piece
top trim
piece
open drawer
side trim
piece
...... chassis trim
edge
3, If using the optional top attaching brackets, place the trim
pieces under the attaching brackets.
4, Remove trim pieces backing paper to expose the adhesive.
5, Place the trim pieces on the trim and press.
6, Finish pushing dishwasher into opening.
19, Place cardboard or other protective covering on the floor in
front of cabinet opening. Place the dishwasher on covering.
20, Begin to route the hoses through the utility hole in the cabinet.
IMPORTANT: Push against the outside edges of drawers as
shown. Do not push against the center of the drawers.
21, Push dishwasher partway into the opening.
iBm_
2,
3,
Leave protective cover on floor.
Open the bottom drawer.
Press in the right-hand runner clip and push it back about 6"
(15.2 cm). Repeat with the left-hand runner clip.
NOTE: When removing the drawer there is limited range of
movement due to the attached water hoses.
4,
runner clip
4, Lift the right edge of the drawer off its runner. Slide that runner
back into the dishwasher.
5, Lift the drawer completely off the left-hand runner.