Avantco 178Z2FHC 사용자 설명서 - 페이지 9

{카테고리_이름} Avantco 178Z2FHC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178Z2FHC 9 페이지. Commercial top mount reach-in freezer, solid door
Avantco 178Z2FHC에 대해서도 마찬가지입니다: 서비스 매뉴얼 (18 페이지)

페이지 인쇄
Avantco 178Z2FHC 사용자 설명서

Troubleshooting

Compressor is Not Running
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Cabinet Temperature Is Too Warm
Thermostat is set too high.
Airflow is blocked.
Low refrigerant levels.
Door is slightly ajar.
Interior Light Is Not Working
Poor switch connection.
Bulb is not connected.
Bulb has burned out.
Fust blown or circuit breaker tripped.
Dirty condensor coil.
Condensation Is Collecting on the Cabinet and/or Floor
Gasket is not sealing properly.
User Manual
Replace fuse or reset circuit breaker.
Plug in power cord
Set thermostat to lower temperature.
Wait for defrost cycle to finish.
Set thermostat to lower temperature.
Re-arrange products to allow for proper air flow. Make
sure there is at least four inches of clearance from the fan.
Contact a service technician to check refrigerant levels.
Make sure door is completely closed.
Poor switch connection.
Make sure the bulb is correctly inserted in the socket.
Replace the bulb.
Replace fuse or reset circuit breaker.
Clean the condensor coil.
Clean, repair, or replace the gasket as necessary.
- 9 -