Avantco 178Z2RGWMS 사용자 설명서 - 페이지 4

{카테고리_이름} Avantco 178Z2RGWMS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178Z2RGWMS 9 페이지. Top mount reach-in refrigerator and freezer

User Manual

Field Convertible Doors

The Avantco Z Series 1 Door Reach Ins (178Z1xxx) ship with a right-hinged door design. If you would

like to convert the reach-in to a left hinged door design (solid door models), you must purchase

the left hinges separately (one set per door - Avantco item #178CFD1KITFR) and follow these

instructions:

Tools Needed:

• Socket Set

• Pliers

• Adjustable Wrench

• Phillips Head Screwdriver

1. Remove the small Philips head screws at the top and bottom door hinge where it attaches to the brackets.

Be careful not to lose the small washers.

2. Next take off the top bracket. It is held on with 3 bolts.

3. The door should come off at this point

- Note: Do not lose the small round brass spacer on the bottom hinge!

4. Remove the bottom bracket. It is held on with 3 bolts.

5. Replace the bottom hinge with the new left hand bottom bracket. It is held on with 3 bolts.

6. At this point, you will need to adjust the top and bottom spring tensioners so the door will close properly.

7. Put the door on the bottom hinge on the left side. You will need to reuse the brass spacer from step 5.

8. Next, place the top bracket on the top of the door before bolting it to the unit with the 3 bolts.

9. Replace the small screws on the top and bottom of the bracket and door spring. Make sure the door is on

properly before you do this.

- 4 -