HIKVISION DS-2CE19U8T-IT3Z 사용자 설명서 - 페이지 8
{카테고리_이름} HIKVISION DS-2CE19U8T-IT3Z에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-2CE19U8T-IT3Z 16 페이지. Turbo hd 4k series vf bullet & turret & dome camera
HIKVISION DS-2CE19U8T-IT3Z에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
3. Loosen screws to remove the clip plate, and take out
the main body.
4. Fix the mounting base on the ceiling with supplied
screws.
Figure 2-9 Fix the Mounting Base on the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement ceiling/wall, expansion bolts are
required to fix the camera. For wooden ceiling/wall,
self-tapping screws are required.
5. Route the cables through the cable hole, or the side
opening.
6. Install the main body to the mounting base and
insert the clip plate.
Figure 2-10 Install the Turret Camera
7. Tighten the screws with the screw driver.
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Figure 2-8 Remove the Clip Plate
Pan Position
[0° to 360°]
Rotation Position
[0° to 360°]
Figure 2-11 3-axis Adjustment
Tilt Position
[0° to 75°]