HIKVISION DS-2CE71D8T-PIRL 사용자 설명서 - 페이지 6
{카테고리_이름} HIKVISION DS-2CE71D8T-PIRL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-2CE71D8T-PIRL 15 페이지. Turret camera
HIKVISION DS-2CE71D8T-PIRL에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 사용자 설명서 (15 페이지)
페이지 인쇄
Figure 2-2 Attach the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden wall/ceiling,
self-tapping screws are required.
5. Route the cables through the cable hole, or the side
opening.
6. Align the camera with the mounting base, and
secure the camera on the mounting base.
Figure 2-3 Secure the Camera with Mounting Base
7. Connect the corresponding cables, such as power
cord, and video cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Pan Position
[0° to 360°]
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.1.2 Mounting with Inclined Ceiling Mount
Before you start:
You need to purchase an inclined ceiling mount
separately.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill screw holes, and the cable hole on the
ceiling/wall according to the supplied drill template.
Fixing Screw
Tilt Position
[0°to 75°]
Figure 2-4 3-axis Adjustment
Expansion Bolts
Rotation Position
[0°to 360°]