IKEA IUD8000WS0 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} IKEA IUD8000WS0에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IUD8000WS0 40 페이지.

페이지 인쇄

Delay start

Select this option to run your dishwasher at a later time or during

off-peak hours. You can add items to the load anytime during the

delay countdown. After adding items, close the door firmly until it

latches. The delay countdown

will not continue if the door is not

latched. Press START/RESUME. If the door is unlatched, the

Start/Resume

indicator flashes. The delay countdown

stops until

you latch the door and press START/RESUME.

To delay the start

1. Press DELAY for a 4-hour delay. The number above or to the

left of the 4 Hour Delay pad glows.

2. Select a wash cycle and option or skip to Step 3 to use the

cycle and options selected for last cycle.

3. Press START/RESUME. (The door must be closed.) The delay

countdown starts, and the cycle will begin after 4 hours.

NOTES:

•

To cancel the delay and cycle, press CANCEL/DRAIN.

•

To cancel the delay and start the cycle, press START/

RESUME.

Follow the progress of your dishwasher with the Cycle Status

indicators.

WASHING

DRYING

CLEAN

SANiTiZED

•

NOTE: Your model may have some or all of the indicators shown

above.

Clean

Clean glows when a cycle is finished. The light turns off when you

open and close the door or press any button.

Sanitized

If you select Sanitize Rinse, Sanitized glows when the Sanitize

Rinse option is finished. If your dishwasher did not properly

sanitize your dishes, the light flashes at the end of the cycle. This

can happen if the cycle is interrupted,

or the water could not be

heated to the required temperature. The light goes off when you

open and close the door or press any button.

This dishwasher

is equipped with an optical sensor wash that

detects water temperature and the amount of soil and detergent.

Wash cycles are adjusted based on what is sensed.

The dishwasher

"senses" wash water quality during a series of

pauses in the wash cycle. The sensor monitors water

temperature and the amount of soil and detergent appearing in

the wash water. It automatically

adjusts the wash cycle for the

best wash. Lightly soiled dishes will use less water and energy.

Heavily soiled dishes will get more water and increased

temperature and wash time. This dishwasher will automatically

adjust the sensor approximately

once a year to your water

quality.

IMPORTANT: The very first wash cycle after installation in your

home will be adjusted to include an additional 2 rinses. This cycle

must not be interrupted for proper sensor adjustment.

If this

adjustment cycle is canceled or stopped before the Clean light

comes on at the end of the cycle, the next wash cycle will repeat

this sensor adjustment.

During drying, you can see steam escaping through the vent at

the upper left corner of the door. This is normal as the heat dries

your dishes.

•--.

,t t-_t".'_

•

1=/'|--t

_.,e

%,_.

t__=

IMPORTANT: The vapor is hot. Do not touch the vent

during drying.

The overfill protection float (in the front right corner of the

dishwasher tub) keeps the dishwasher from overfilling. It must be

in place for the dishwasher to operate.

Check under the float for objects that may keep the protector

from moving up or down.