Avantco JBC-50 사용자 설명서 - 페이지 5

{카테고리_이름} Avantco JBC-50에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco JBC-50 5 페이지. Commercial bottle cooler

Troubleshooting

Compressor is Not Running

Fuse blown or circuit breaker tripped.

Power cord unplugged.

Thermostat set too high.

Cabinet in defrost cycle.

Cabinet Temperature is too Warm

Thermostat is set too high.

Airflow is blocked.

Low refrigerant levels.

Door is slightly ajar.

Units in this manual are backed by a 1 year parts and labor warranty, with a 5 year warranty on the

compressor. For warranty inquiries or service, first locate:

• The model number and cabinet serial number (located on the front of the unit, or inside the

door jamb).

• The bold number on the service plate (located on the front of the unit).

Next, call 1-800-678-5517. Be sure to have the model number, cabinet serial number, and service

plate number available when contacting service technicians.

This warranty does not apply to, and Avantco is not responsible for, any warranty claims made on

products sold or used outside of the United States.

RESIDENTIAL USERS: Avantco assumes no liability for parts or labor coverage for component

failure or other damages resulting from installation in non-commercial or residential applications.

User Manual

Replace fuse or reset circuit breaker.

Plug in power cord

Set thermostat to lower temperature.

Wait for defrost cycle to finish.

Set thermostat to lower temperature.

Re-arrange products to allow for proper air flow.

Make sure there is at least four inches of clearance

from the fan.

Contact a service technician to chek refrigerant levels.

Make sure door is completely closed.

- 5 -