KitchenAid KUDE20IXBL6 사용자 지침 - 페이지 10

{카테고리_이름} KitchenAid KUDE20IXBL6에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KUDE20IXBL6 19 페이지.

페이지 인쇄

OPTIONS

CAN BE

WHAT IT DOES

ADDED TIME TO CYCLE

ADDED

SELECTED WITH

WATER

TYPICAL

MAX

GALLONS

(LITERS)

Control Lock

Avoids unintended use of the dishwasher

between cycles, or cycle and option changes during a cycle.

To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control

Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button

while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed

while the

controls are locked.

NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL, or by opening and

closing the door before you are able to turn Control Lock off.

To turn off Control Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The

light turns off.

NOTE: If your model requires you to press and hold 4 HOUR DELAY to lock the controls, the Control Lock LED will be

on or off to indicate if Control Lock is active or not.

CONTROL

PURPOSE

COMMENTS

To start or resume a

f the door is Opened during a CYcleorthe power is interrupted the StartJResume indicator

wash cYCle

flashes

The Cycle will not resume until the door is Closed and START/RESUME is pressed.

NOTE" If the Start/Resume button is located on top of door, push door firm!y closed within

3 seconds of pressing START/RESUME, If the door is not closed within 3 seconds, the

StartjResume

button LED wi!l flash, an audib!e tone will be heard, and the cycle will not

start.

To reset any cycle or

options during

selection.

To cancel a wash

cycle after it's

started.

Press and hold CANCEL/DRAIN to reset any control selections made.

See "Canceling A Cycle After Dishwasher Is Started" and "Changing A Cycle After

Dishwasher Is Started" sections.

To turn the audible

Press and h01d the Hi:Temp scrub button foi3 seconds to turn the audible tones on or off.

tones on or off.

Only audible tones for confirming

button presses can be turned on/off. Important audible

tones, such as indicating a cyc!e has been interrupted,

cann0t be deactivated.

t:eedback

CONTROL

PURPOSE

COMMENTS

w:iiillDII,:_ c;_il ; i,,iz:i

The Cycle Status indicator

clean indicatoi glows when a CYcle is finished.

•

Lghtsareusedtofo

owthe

........

.....

If y0u select the Sanl Rinse option, when the Sanl Rinse cycle !s f!nlshed,

progress of me a snwasner

, ,

_ ,

the Sanitized indicator g!ows, lf y0ur dishwasher did not properly sanitize

cycle Locatea on ire front

of ;he dish aslier for front

your dishes, the light flashes at the end of the cyclel This can happen if the

. ,

cycle is interrupted

or the water could not be heated to the [equired

control moaels ana ocaiea

tem-erature

on the top of the door for

...................

hidden control models.

The Clean and Sanitized lights go offwhen you open and close the door or

)ress

and hold CANCEL

The Front Indicator Light or

The light will be blue if the dishwasher is washing or rinsing. The light will

Single Exterior Light (A)

be red when the dishwasher is drying. The light will be green to indicate

shows progress of your

that the cycle is complete. If the Front Indicator Light is blinking, see

dishwasher cycle by color

"Troubleshooting"

section.

(for hidden control models

only).

The

CYcle Status Display is

The indicators Wi!l inform you if you are able to add a dish to the cycle afte r

used to follow the progress

it has started. It wi!l a!so inform you if the dishwasher

is washing, rinsing,

of the dishwasher cycle, and

drying, complete, and/or sanitized. They will show whether the control is

to show other informationl

locked and/or the delay oPtion is se!ected. A series of bars wi!! count down

(Avai abe on some models

the duration of the cycle remaining from left to right. Each bar equals

instead of Cycle Status

approximately

24 minutes of cycle length The bars will a!so count down

Indicator

Lights)the

delay feature from left to right, and the delay indicator wi!! be activated.