IKEA MDB7759SAS0 설치 지침 매뉴얼 - 페이지 18

{카테고리_이름} IKEA MDB7759SAS0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA MDB7759SAS0 48 페이지. Undercounter dishwasher stainless steel tub

IMPORTANT: If wheels were removed, cover the floor when

moving the dishwasher to avoid damage to the floor. Slowly move

dishwasher completely into cabinet opening. Do not kink or pinch

water line, drain hose, power supply cord or direct wire between

dishwasher and cabinet. Remove cardboard from under

dishwasher.

NOTES:

•

It is all right if dishwasher fits tightly into cabinet opening. Do

not remove insulation blanket-

the blanket reduces the sound

level.

•

If using power cord, make sure to route end through hole in

cutout before sliding dishwasher into cabinet opening.

Align front of dishwasher door panel with front of cabinet doors.

You may need to adjust alignment to be even with your cabinets.

Check that leveling legs are firmly against the floor. Close and

latch the door, and place level against the front panel. Check that

dishwasher is centered from front to back in the opening. If

needed, adjust leveling leg until dishwasher is plumb. Repeat for

other side of dishwasher.

Helpful Tip: Push up on front of dishwasher to raise dishwasher

off the ground to adjust front legs. With some installations, it may

be easier to adjust the front leg using the ¾6" hex head socket or

adjustable wrench.

Place level against top front opening of tub. Check that

dishwasher is level from side-to-side.

If dishwasher is not level,

adjust front legs up or down until dishwasher is level. Close the

dishwasher door.

Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm) onto

copper tubing.