Avantco 178UDD3HCS 사용자 설명서 - 페이지 6
{카테고리_이름} Avantco 178UDD3HCS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178UDD3HCS 19 페이지. Beer dispensers
Avantco 178UDD3HCS에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 사용자 설명서 (19 페이지)
페이지 인쇄
User Manual
Electrical Instruction
When using electrical appliances basic safety precautions should be followed:
- This cooler must be properly installed and located in accordance with the installation
service representative.
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
- Unplug the unit from the electrical outlet before cleaning or making repairs.
- Setting the temperature controls to the (0) zero position does not remove all power.
Please ensure that the required voltage for the compressor is being supplied at all times.
If the voltage is unstable, please select a suitable automatic voltage regulator.
!
CAUTION: Low or high voltage can damage the refrigeration unit.
- All units should be plugged into a grounded and properly-sized electrical outlet with appropriate
overcurrent protection. Please refer to the electrical requirement on the nameplate. The power
cord of this cooler is equipped with a grounding plug which fits a standard grounding wall outlet
to minimize the possibility of electrical shock hazard.
Standard Plug: NEMA 5-15P
If the outlet is a standard 2-prong outlet, it must be replaced with the properly
grounded wall outlet. NEVER USE AN ADAPTER PLUG!
- Have the wall outlet and circuit checked by a qualified electrician to make sure the
outlet is properly grounded. Check the incoming voltage with a voltmeter.
- DO NOT USE EXTENSION CORDS. The use of extension cords to connect the cooler will void
warranty. The unit must be close enough to the electrical outlet so that extension cords are
never used.
- The cooler should always be plugged into its own dedicated circuit with a voltage rating that
matches the rating plate. This provides the best performance and also prevents overloading
wiring circuits which could become a fire hazard from overheated wires.
- Never unplug your cooler by pulling on the power cord. Always grip the plug firmly and pull
straight out from the outlet.
- Immediately repair or replace all power cords that have become frayed or otherwise damaged.
Do not use a power cord that has cracks or abrasion damage along its length or at either of
its ends.
- When moving the cooler away from the wall be careful not to run over or damage the power cord.
It is strongly recommended that any servicing be performed by an
authorized service representative.
- 6 -