ENGLISH
The indicators:
,
flashing.
2. Press
.
The indicators
,
The indicator
still flashes.
The indicator
starts flashing. The
number of flashes indicates the current
water softener setting (e.g. 5 flashes +
pause + 5 flashes... = level 5).
3. Press
to change the setting. Each
pressing of the button
level number by one. After reaching
level 10, the count starts from level 1.
4. Press on/off to confirm and save the
setting.
The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the rinse
aid indicator is turned on notifying to refill
rinse aid. If the drying results are
satisfactory while using multi-tablets only, it
is possible to deactivate the notification for
refilling rinse aid. However, for best drying
performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid empty
notification
Make sure the appliance is in the
programme selection mode.
1. Press and hold simultaneously
to enter the user mode.
The indicators:
,
flashing.
,
and
start
and
are off.
increases the
and
,
and
start
2. Press
.
The indicators:
,
The indicator
still flashes.
The indicator
shows the current setting.
If on = rinse aid empty notification is on, if
off = rinse aid empty notification is off.
3. Press
to change the setting.
4. Press on/off to confirm and save the
setting.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is complete. This
acoustic signal is activated by default and
you can deactivate it.
In addition, an acoustic signal sounds
before the AutoOpen opens the door. This
acoustic signal stops only if AutoOpen is
deactivated.
How to deactivate the acoustic signals
Make sure the appliance is in the
programme selection mode.
1. To enter the user mode, press and hold
simultaneously
The indicators:
,
flashing.
2. Press
.
The indicators:
,
The indicator
still flashes.
The indicator
shows the current setting.
If on = the acoustic signal is active. If off =
the acoustic signal is disabled.
3. Press
to change the setting.
4. Press on/off to confirm and save the
setting.
11
and
are off.
and
.
,
and
start
and
are off.
페이지 인쇄