Avantco UDD1 사용자 설명서 - 페이지 9

{카테고리_이름} Avantco UDD1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco UDD1 17 페이지.

Avantco UDD1 사용자 설명서
Knockout CO
These is the recommended procedure for
installing a remote CO
1 . Remove black knockout plug with pliers . (See images below for plug locations)
2 . Use drill with 1/2" bit to bore a whole straight back through wall into compressor compartment .
3 . Snake CO
line through hole, down and around, exiting behind rear caster underneath grill .
2
4 . Seal hole around CO
*Depending on setup and amount of kegs, a CO
NOTE: In models UDD1 & UDD1S, the CO
tank (up to 5 lbs . in size) can be placed inside
the cooler to maintain complete mobility
CAUTION
CO
tanks are potentially dangerous because of the pressure
2
they contain . If you are unfamiliar with their use or the use of
a CO
regulator, seek information from your local distributor,
2
or beverage man before proceeding .
Installation
2
container in your Avantco unit .
2
line with silicone sealer to prevent cold air leakage .
2
2
User Manual
Tools:
-
-
-
-
manifold may be needed .
2
- 9 -
Pliers
Power Drill
Silicone Sealer
1/2" Drill Bit