IKEA TORSBODA 매뉴얼 - 페이지 33
{카테고리_이름} IKEA TORSBODA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA TORSBODA 40 페이지.
IKEA TORSBODA에 대해서도 마찬가지입니다: 매뉴얼 (33 페이지), 매뉴얼 (16 페이지)
FAULT
Detergent residue is present in the
detergent dispenser or the tablet
collecting tray.
Excessive formation of foam oc-
curs.
Information on display panel
FAULT
Special salt refill indicator lights up. Insufficient special salt.
Refill indicator for special salt does
not light up.
Refill indicator for rinse aid lights
up.
Refill indicator for rinse aid does
not light up.
Malfunctions
FAULT
Water is left in the appliance at the
end of the programme.
Appliance cannot be switched on or
operated.
Appliance does not start.
Programme starts automatically.
Appliance stops during the pro-
gramme or cuts out.
CAUSE
Spray arms were blocked by table-
ware so detergent was not rinsed
out.
Detergent dispenser was damp
when detergent was added.
Hand washing-up liquid is present
in dispenser for rinse aid.
Rinse aid has been spilled.
Detergent or appliance care
product used causes excessive
foaming.
CAUSE
Sensor does not detect special salt
tablets.
Water softening system is switched
off.
Insufficient rinse aid.
Rinse aid system is switched off.
CAUSE
Filter system or area under the fil-
ters is blocked.
Programme has not yet ended.
Appliance functions have failed.
The mains fuse has tripped.
Mains cable is not inserted.
Appliance door is not closed prop-
erly.
You did not wait until programme
ended.
Appliance door is not closed prop-
erly.
Power and/or water supply has
been interrupted.
Top basket is pressing against in-
ner door and preventing appliance
door from being closed securely.
TROUBLESHOOTING
Check that the spray arms are not blocked
●
and can rotate freely.
Only add detergent to a detergent dispenser
●
when dry.
Immediately add rinse aid to the dispenser.
●
→ "Adding rinse aid", Page 18
Remove the rinse aid with a cloth.
●
Change the brand of detergent.
●
TROUBLESHOOTING
Add "Special salt" → Page 18.
●
Do not use special salt tablets.
●
Set the water softening system.
●
→ "Setting the water softening system", Page 17
Add "Rinse aid" → Page 18.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 19
Set the amount of rinse aid to be dispensed.
●
→ "Setting the amount of rinse aid", Page 19
TROUBLESHOOTING
Clean the "Filters" → Page 25.
1.
Clean the "Wastewater pump" → Page 35.
2.
Wait until the programme ends or cancel the
●
programme with Reset.
→ "Terminate programme", Page 22
●
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
Check the relevant fuse.
●
Check whether the socket works.
1.
Check whether the mains cable is properly in-
2.
serted in the socket and on the rear of the
appliance.
Close the appliance door.
●
→ "Terminate programme", Page 22
●
Close the appliance door.
●
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the appli-
●
ance is being pressed in by a socket or hose
holder that has not been removed.
33