GAPOSA XQ50 매뉴얼 - 페이지 7

{카테고리_이름} GAPOSA XQ50에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA XQ50 16 페이지. Tubular motors with mechanical limit switch and integrated receiver.
GAPOSA XQ50에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 지침 (4 페이지), 프로그래밍 퀵 매뉴얼 (7 페이지), 매뉴얼 (15 페이지), 사용 설명서 (13 페이지), 매뉴얼 (13 페이지), 사용 설명서 (8 페이지)

페이지 인쇄
GAPOSA XQ50 매뉴얼
ELECTRICAL CONNECTION
IMPORTANT INFORMATION FOR ELECTRICIANS
• It is possible to connect in parallel electronic motors to a switch in
residential applications where the total power cable length does
not exceed 10 meters. The number of motors paralleled together
is limited to 4-5 according to the switch total amperage capacity.
• Electronic motors cannot be paralleled connected together
when controlled by a Building Management system (BMS).
• Compatibility between electronic motors and BMS must be
approved and tested by manufacturer of BMS.
• For standard motor operation only a standard switch allowing either
UP or DOWN but not both at the same time must be used. Only
mechanically or electrically interlocked switches can be used.
• Motors with electronic limits can be connected in parallel. The
maximum load of the switch must never be exceeded.
• When changing from UP to DOWN or vice versa, the switchover time
must at least be 0.5 seconds and effected through an OFF position.
Only switches with a defined neutral position or one with a built-in
switching delay should be used.
• An "active path" control unit which monitors the current draw is in
conflict with the motor and cannot be used.
2/2