BERNHARDT design a.k.a. Easel base 사용 설명서 - 페이지 4

{카테고리_이름} BERNHARDT design a.k.a. Easel base에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BERNHARDT design a.k.a. Easel base 20 페이지.

Step 7

Using a ¼" drill bit - drill through the pre-machined holes

on the Workwall Structure into the drywall. This will locate

the locations of the Snaptoggles®.

Note: you will also need to drill new holes through the

Workwall Structure along the line where you have

previously located the wall studs so that you can

connect the panel to the studs with a #8 or #10 screw.

Step 8

Once all the holes have been drilled, remove the temporary

drywall screws and set the first Workwall Structure section

aside. Using a ½" drill bit, open up all the ¼" holes just

drilled into the drywall to ½".

Step 9

Install 1 Toggler® Snaptoggle® wall anchor into each of

the ½" holes.

Step 10

The first Workwall Structure section can now be attached

to the wall using the ¼"-20 bolts into each of the Toggler®

wall anchors. Be sure to re-level before securing

the panel.

September 2012