BERNHARDT design yuno 전기 설치 지침 - 페이지 2
{카테고리_이름} BERNHARDT design yuno에 대한 전기 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. BERNHARDT design yuno 8 페이지.
페이지 인쇄Leg Installation Instructions
Yuno tables will require a small amount of field assembly. The Yuno tables will involve installation of the leg assembly, power infeed wire
management clip, and the ganging brackets.
Read the following instructions for installation of the Yuno leg assembly and power infeed wire management clip. The following
installation instructions show a yuno table with power. For assembly of yuno tables without power follow steps one and two,
excluding the power infeed wire management clip installation.
1
2
Yuno leg assemblies are unique in that they can be placed on either
end of the table top.
Attach each leg assembly to the
crossmember using screw (B) and to
the table top using screw (A).
3
After securing the legs to both the table top and crossmember assembly, a customer
assembling a powered yuno table will attach the power infeed wire management clips
using screw (C). The illustrations below are for a right hand power infeed table, for a
left hand power infeed mirror the illustration.
Right hand facing starter table
1
Begin by carefully removing all components from the box, placing the table top face down on a clean, protected surface.
Yuno table tops will come pre-assembled with crossmember attachment bar, power modules (wiring pre-assembled) and
felt shroud.
Yuno tables will come with the following mechanical fasteners that are
required for leg and power infeed wire clip installation:
(A)
(B)
Right hand facing add-on table
(x12)
(A)
(B)
(x4)
(C)
(x2)
(D)
(x2)
yuno installation instructions
leg installation instructions
A torx T30 bit will be required for
installation.
(C)