GAPOSA EMITTO SMART16 설치 관리자 매뉴얼 - 페이지 6

{카테고리_이름} GAPOSA EMITTO SMART16에 대한 설치 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA EMITTO SMART16 7 페이지. 16 channels hand held display remote with timer
GAPOSA EMITTO SMART16에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

ERASING TRANSMITTERS (Fig. 3)

Push simultanously SYNC and STOP of the transmitter until the motor makes a brief movement in both

directions. Only the transmitter used for this procedure has been deleted from motor memory

FIG. 3

RESET MOTOR MEMORY

OPTION 1 (Fig. 4) - Using an already programmed transmitter

Press and hold both SYNC and STOP buttons till the motor makes first a brief jog and, after a while, a

second long jog. Memory is now empty.

FIG. 4

OPTION 2 (Fig. 5) - Without an already programmed transmitter

1. Switch the motor power supply OFF. Then switch it ON.

2. Within 8 seconds, using any Gaposa transmitter, press and hold both SYNC and STOP buttons until the

motor makes a long jog. Memory is now empty.

FIG. 5

OFF

LIMIT SWITCH SETUP (Fig. 6)

ATTENTION: ALWAYS SET THE UP LIMIT SWITCH FIRST

1. Push LIMIT till the motor makes a brief movement in both direction

Note: during "programming mode" the operations are in "deadman control"

2. Press and hold the

3. Press the

STOP to set the UP limit position. The motor makes a brief jog.

4. Press and hold the

5. Press the

STOP to set the DOWN limit position. The motor makes a brief jog.

Note: accurate limit setting can be performed when UPWARD or DOWNWARD by pressing a second time LIMIT:

the motor then moves slowly in steps towards to the desired limit. Always press STOP button to set the limit

position.

www.AVOutlet.com

(Just for motors with electronic limit switch)

UP button and run the motor to the desired UP limit position.

DOWN button and run the motor to the desired DOWN limit position.