Avantco 177HEAT1836 사용자 설명서 - 페이지 19

{카테고리_이름} Avantco 177HEAT1836에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 177HEAT1836 20 페이지. Heater/proofer cabinets

Troubleshooting

CAUTION

Before disassembling unit, electrical power must be disconnected by unplugging the unit. Failure to unplug the unit

prior to servicing may result in electrical shock.

Each unit is shipped with this instruction manual and should be used as a reference guide for all service areas. The

manual provides a picture of the drawer, showing the location of electrical components and a description of each. If the

unit does not operate correctly, or malfunctions for any reason, the following check list should provide a solution.

1) Check to make sure power cord is firmly plugged into the wall outlet.

2) Check circuit breaker of wall outlet and reset if necessary.

IF unit fails to start, please do the following:

3) Remove heat drawer from cabinet. Remove bottom cover of drawer. Visually inspect to observe for:

a. Loose or disconnected wires

b. Black or burnt marks on any components

c. Loose heating elements

4) If any burn marks or discoloration of wires is noted on any component, the component along with all wires attached

to the damaged component must be replaced.

5) If a heater element is loose, or if it has broken loose from mounting tabs, the wires will short out on the metal,

causing permanent damage. Both the element and main power switch (with wires on switch) must be replaced.

6) If the temperature on the LED Thermometer is not reading a constant temperature, it must be replaced along with its

power supply transformer.

www.AvantcoEquipment.com

User Manual