GAPOSA XQ50 프로그래밍 퀵 매뉴얼 - 페이지 3
{카테고리_이름} GAPOSA XQ50에 대한 프로그래밍 퀵 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA XQ50 7 페이지. Tubular motors with mechanical limit switch and integrated receiver.
GAPOSA XQ50에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 지침 (4 페이지), 매뉴얼 (15 페이지), 사용 설명서 (13 페이지), 매뉴얼 (13 페이지), 매뉴얼 (16 페이지), 사용 설명서 (8 페이지)
페이지 인쇄
MANUAL LIMIT SETTING
1. CONNECT POWER TO THE MOTOR
2. PAIRING THE REMOTE
1
Press and hold Prog-TX (4)
on the back of the remote
till the motors starts
running
3. CHANGING DIRECTION
1
Press and hold Prog-TX (4)
on the back of the remote till
the motors starts running
4. SETTING THE LIMITS (Always set TOP limit first)
1
Press and hold the Prog-FC (5)
button on the back of the remote
till the motor makes a brief jog
2
Check the motor rotational direction then
release Prog-TX (4). Motor stops
STOP
2
Press UP (1) button on
the front and hold it for
more than 2 sec: the
motor starts running
automatically upwards to
set the TOP limit.
When you reach the
position of the top limit
press STOP. Motor stops
3
Within 5 seconds, press the corresponding button:
- UP if the motor turns upwards
- DOWN if the motor turns downwards
Remote is now paired
1
To confirm press STOP
again.
Motors jogs: TOP limit is
now set
2
Release Prog-TX (4) then press STOP.
The motor makes a brief jog.
Direction of the motor has been
reversed
IMPORTANT: the change of direction
of operation must be performed
BEFORE initiating limit setting
procedure otherwise limits must be
reset
2"
3
Press DOWN (3) button on the front
and hold it for more than 2 sec: the
motor starts running automatically
downwards to set the BOTTOM limit.
When the roller shutter is completely
closed the motor stops setting the
BOTTOM limit.
BOTTOM limit is now set