GAPOSA M1A 참조 매뉴얼 - 페이지 9

{카테고리_이름} GAPOSA M1A에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA M1A 14 페이지. Safety brake
GAPOSA M1A에 대해서도 마찬가지입니다: 참조 매뉴얼 (11 페이지)

IMPORTANT: CHECK THAT THE SAFETY BRAKE HAS NOT UNDERGONE PREVIOUS

TESTS AND STRONG STRESSES.

REINSTATEMENT

M1A - P200 - M3A - M4A - M7A and M10A safety brakes can stop the rotation of the shaft

to prevent any dangerous acceleration more than once, but each time they must be

reinstated according to the following procedure.

REINSTATEMENT PROCEDURE

(from M1A to M10A models only)

1. Unscrew, according to the sequence in fig. 2, the screws placed on the central body of

the safety brake.

2. Replace the pin projecting out of the central body in its initial position, pushing it in

the opposite direction of the arrow, till the micro switch is set going again; By the M1A

and P200 the hole of the ring must be replaced in the middle of the cavity.

3. Tighten the screws once slightly according to the sequence in fig. 2 and then com-

plete the screwing up always respecting the sequence by a dynamometrical key

setting it according to Tab. A.

ATTENTION: Each time that the M15A, the M20A and the M30A safety brakes stop,

in order to be reinstated, they must be sent back to GAPOSA srl.

MAINTENANCE

If the installation procedure has been respected, the safety brake does not require any

maintenance.