Avantco 178AWT60RHC 사용자 설명서 - 페이지 9

{카테고리_이름} Avantco 178AWT60RHC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178AWT60RHC 10 페이지. Commercial refrigerators and freezers

A dusty condenser may lead to high energy consumption, less cooling effectiveness, and

compressor damage.

Condenser Coil Cleaning Instructions:

The condenser coil is located at the bottom behind the panel.

1. Disconnect the electrical power from the unit.

2. Remove the front cover and base cover with a screwdriver.

3. Using a soft brush and / or vacuum, remove the dirt, lint, etc. from the finned condenser coil in a

vertical direction.

4. Clean the condenser with a commercial condenser coil cleaner, available from any kitchen

equipment retailer. Ex. Nobel Chemical Tech Line

5. After cleaning, straighten any bent condenser fins with a fin comb.

6. When finished, be sure to reinstall the front cover and base cover.

7. Reconnect the electrical power to the unit.

Troubleshooting

Compressor Not Running

Fuse blown or circuit breaker tripped.

Power cord unplugged.

Thermostat set too high.

Cabinet in defrost cycle.

Condensing Units Run for Long Periods of Time

Excessive amount of warm product placed in

cabinet.

Prolonged door opening or door ajar.

Door gasket(s) not sealing properly.

Dirty condenser coil.

Evaporator coil iced over.

www.AvantcoRefrigeration.com

User Manual

Replace fuse or reset circuit breaker.

Plug in power cord.

Set thermostat to lower temperature.

Wait for defrost cycle to finish.

Allow adequate time for product to cool down.

Ensure doors are closed when not in use. Avoid

opening doors for long periods of time.

Ensure gaskets are snapped in completely. Remove

gasket and wash with soap and water. Check

condition of gasket and replace if necessary.

Clean the condenser coil.

Unplug unit and allow coil to defrost. Make sure

thermostat is not set too cold. Ensure that door

gasket(s) are sealing properly.