Avantco 178GF36HC 사용자 설명서 - 페이지 4

{카테고리_이름} Avantco 178GF36HC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178GF36HC 6 페이지.

User Manual

Electrical

• Please ensure that the required voltage is being supplied at all times.

• The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate

over-current protection. Please refer to the electrical requirements on the unit's nameplate.

• The unit should have its own dedicated outlet.

• Do not use extension cords.

• Ensure the unit is not resting on or against the electrical cord.

• If the unit is not in use for a long period of time, please unplug the unit from the outlet.

• To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.

• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could

cause damage to the compressor.

Adjusting the Temperature

Your new freezer is already factory-set to run at optimum

temperatures for food safety and should require no

adjustments.

Freezers are set to cycle between a minimum temperature of -5 degrees Fahrenheit and a maximum

temperature of 2 degrees Fahrenheit.

Adjusting the temperature changes the minimum temperature your unit will run at. Your unit will not

run constantly at this setting. To change it, follow these instructions:

Digital Control Units

• Hold "SET" for 1 sec. The display will flash the current minimum temperature.

• Use the arrow buttons to adjust the minimum temperature you want it to run at.

• Press "SET" again to save your settings

Always remember to calculate the differential if you change the minimum temperature setting. The

cabinet temperature will fluctuate up to +7 degrees over your set minimum temperature as the

compressor runs and shuts off. Setting the temperature too high will result in unsafe maximum

temperatures and possible health code violations.

Freezer Control

- 4 -

Prg

aux

mute

Set

def