Avantco 178SS1F2HC 사용자 설명서 - 페이지 3

{카테고리_이름} Avantco 178SS1F2HC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178SS1F2HC 8 페이지. Reach-in refrigerators and freezers
Avantco 178SS1F2HC에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)

페이지 인쇄
Avantco 178SS1F2HC 사용자 설명서

Installation

Please read this manual thoroughly prior to equipment set-up, operation and maintenance.
Important!!! Please Read Before Installation
• If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to
promote proper air flow. Failure to install the shelves properly is considered user-error and is not
covered by warranty.
• If the unit has recently been transported on its side, please let the unit stand upright for a
minimum of 24 hours before plugging it in.
• Make sure the unit has reached the desired temperature before loading the unit with products.
• Make sure all accessories are installed (shelves, shelf clips, etc...) before plugging in the unit.
• Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing / repair.
• Do not hang on doors or stand inside the unit.
• Please read through this manual in its entirety.
Field Convertible Doors
The Avantco 178SS1RHC and 178SS1FHC both ship with a right-hinged door design. If you would
like to convert the reach-in to a left hinged door design (solid door models), you must purchase the
left hinges seperately (Avantco item #178SS1KITFR ) and follow these instructions:
Tools Needed:
Socket Set
Pliers
Adjustable Wrench
Phillips Head Screwdriver
1. Remove the bottom vent, which is held on by loosening the 4 Phillips head screws that hold it on.
You do not need to remove the whole way, as the vent will slide up and out.
2. Remove the top panel next. It is held on with 2 small screws. Once the screws are out, the top
panel will hinge up.
3. Remove the small Philips head screws at the top and bottom door hinge where it attaches to the
brackets. Be careful not to lose the small washers.
4. Next take off the top bracket. It is held on with 3 bolts.
User Manual
- 3 -