Makita 1806B 사용 설명서 - 페이지 7
{카테고리_이름} Makita 1806B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 1806B 13 페이지. Power planer
Makita 1806B에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 부품 분석 (3 페이지), 사용 설명서 (13 페이지), 사용 설명서 (10 페이지), 사용 설명서 (11 페이지)
![Makita 1806B 사용 설명서](/uploads/products/server2/2088699/2088699.jpg)
Connecting a vacuum cleaner
004888
For European countries and areas
When you wish to perform clean planing operation,
connect a Makita vacuum cleaner to your tool. Install the
nozzle on the tool using the screws. Then connect a hose
of the vacuum cleaner to the nozzle as shown in the
figures.
For other countries and areas
A nozzle and joint (optional accessories) are necessary
to connect a Makita vacuum cleaner to your tool. Consult
a Makita catalogue or representative on the nozzle and
joint.
1
2
004893
OPERATION
Planing operation
1
002578
First, rest the tool front base flat upon the workpiece
surface without the blades making any contact. Switch
on and wait until the blades attain full speed. Then move
the tool gently forward. Apply pressure on the front of tool
at the start of planing, and at the back at the end of
planing. Planing will be easier if you incline the workpiece
in stationary fashion, so that you can plane somewhat
downhill.
1. Nozzle
1
2. Screwdriver
2
1. Nozzle
2. Vacuum cleaner
1. End
2. Start
2
The speed and depth of cut determine the kind of finish.
The power planer keeps cutting at a speed that will not
result in jamming by chips. For rough cutting, the depth of
cut can be increased, while for a good finish you should
reduce the depth of cut and advance the tool more
slowly.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Sharpening the planer blades
Always keep your blades sharp for the best performance
possible. Use the sharpening holder to remove nicks and
produce a fine edge.
1
002591
First, loosen the two wing nuts on the holder and insert
the blades (A) and (B), so that they contact the sides (C)
and (D). Then tighten the wing nuts.
1
2
3
002589
Immerse the dressing stone in water for 2 or 3 minutes
before sharpening. Hold the holder so that the both
blades contact the dressing stone for simultaneous
sharpening at the same angle.
7
1. Sharpening
holder
1. Wing nut
2. Blade (A)
3. Blade (B)
4. Side (D)
5. Side (C)
5
4