Makita 2012NB 사용 설명서 - 페이지 7

{카테고리_이름} Makita 2012NB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 2012NB 13 페이지. Thicknesser
Makita 2012NB에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (14 페이지), 사용 설명서 (20 페이지), 사용 설명서 (17 페이지)

페이지 인쇄

1. Maintenance

004468

004469

Installing blades

CAUTION:

Use only Makita socket wrench provided to tighten

•

the blade installation bolts. The use of any other

socket wrench may cause overtightening or

insufficient tightening of the bolts, resulting in

severe injury.

For throw away blades only

Provide a flat wood block approximately 300 mm long

and 100 mm wide. Place the blade and the set plate on

the wood block so that the blade locating lug of the set

plate rests in the groove of the blade. Adjust the set plate

so that both ends of the blade protrude approximately 1

mm beyond the end of the set plate. Place the two

magnetic holders on the set plate and push them until the

claw contacts the blade.

1mm (3/64")

003718

Grip the magnetic holder and slip the heel of the set plate

into the groove in the drum. Install the blade installation

bolts.

1. Socket wrench

2. Lock plate

3. Blade installation

bolt

1. Set plate

1. Magnetic holder

2. Set plate

3. Blade

003716

After tightening all the blade installation bolts lightly and

evenly from the center to the outside, tighten them

completely following the same sequence. Remove the

magnetic holders from the set plate.

003717

Install the other blade as described above. Rotate the

drum slowly while pressing the lock plate to make sure

there is nothing abnormal. Then install the chip cover and

the side cover.

CAUTION:

Do not tighten the blade installation bolts without

•

the blade locating lug of the set plate correctly

resting in the groove of the blade. This may cause

damage to the blade and potential injury to the

operator.

Do not turn the tool on with the chip cover removed.

•

When installing the chip cover, make sure that the

•

chain is not caught by the chip cover.

For standard blades only

Place the blade on the blade gauge so that the blade

edge is perfectly flush with the inside of the front rib (A).

Place the set plate on the blade, then gently press the

heel of the set plate flush with the back side of the blade

gauge (B). Tighten the screws to secure the set plate to

the blade.

004470

1. Blade installation

bolts

2. Set plate

3. Magnetic holder

4. Drum

5. Blade

6. Claw

1. Socket wrench

2. Magnetic

holders

1. Screw

2. Set plate

3. Blade

4. Blade gauge