Makita 2012NB 사용 설명서 - 페이지 8
{카테고리_이름} Makita 2012NB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 2012NB 20 페이지. Thicknesser
Makita 2012NB에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (14 페이지), 사용 설명서 (13 페이지), 사용 설명서 (17 페이지)
페이지 인쇄
Operation
CAUTION:
Two or more pieces of narrow but similar thickness stock can be passed through the
planer side by side. However, allow some spacing between the stock to permit the feed
rollers to grip the thinnest piece. Otherwise, a slightly thinner piece could be kicked back
by the cutterhead
1
Place the workpiece flat on the table top.
Determine the depth of cut as described
before. Switch on the tool and wait until
the blades attain full speed. The workpiece
should not be in contact with the feed roller
when you turn the tool on. Then insert the
workpiece flush with the table top.
When cutting a long or heavy workpiece,
lift up its end slightly at the start and the
end of the cut to avoid gouging or sniping
at the extreme ends of the workpiece.
Less than 130 mm (5-1/8") long
c
Less than
I30 m m ( 5
t/8 )
-
Having a groove more
than
130
mm
(5-1/8") wide
-
More lhan
130 mm ( 5
1/E
)
= E I % G r l
*Stop the tool when the workpiece has stalled. Allowing the tool to run with a stalled
workpiece causes rapid wearing of the feed rollers.
8