Makita 3601B 사용 설명서 - 페이지 8

{카테고리_이름} Makita 3601B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3601B 13 페이지. Router
Makita 3601B에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (13 페이지)

1. Bit

2. Base

3. Templet

4. Workpiece

5. Distance (X)

6. Outside diameter of the templet

guide

7. Templet guide

1. Wing bolt (B)

2. Fine adjusting screw

3. Wing bolt (A)

4. Trimmer guide

5. Wing bolt (C)

6. Guide roller

Secure the templet to the workpiece. Place the tool on the templet and move

003695

the tool with the templet guide sliding along the side of the templet.

NOTE:

•

The workpiece will be cut a slightly different size from the templet. Allow

for the distance (X) between the bit and the outside of the templet guide.

The distance (X) can be calculated by using the following equation:

Distance (X) = (outside diameter of the templet guide - bit diameter) / 2

Trimmer guide (Accessory)

005047

Trimming, curved cuts in veneers for furniture and the like can be done easily

with the trimmer guide. The guide roller rides the curve and assures a fine cut.

Install the trimmer guide on the tool base with the wing bolts (B). Loosen the

005048

wing bolt (A) and adjust the distance between the bit and the trimmer guide by

turning the fine adjusting screw (1.5 mm per turn). At the desired distance,

tighten the wing bolt (A) to secure the trimmer guide in place. When adjusting

the guide roller up or down, loosen the wing bolt (C). After adjusting it, tighten

the wing bolt (C) securely.