Makita 3601B 사용 설명서 - 페이지 7

{카테고리_이름} Makita 3601B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3601B 13 페이지. Router
Makita 3601B에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (20 페이지)

페이지 인쇄
Makita 3601B 사용 설명서
tighten the wing bolt (C) securely.
1
2
3
4
005048
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
003701
Connecting a vacuum cleaner
006286
1
2
3
4
006287
Connect a vacuum hose to the tool and further connect
another end of it to the vacuum cleaner. Secure the hose
to the router base with a screw in the figure.
1. Wing bolt (B)
2. Fine adjusting
screw
3. Wing bolt (A)
4. Trimmer guide
5. Wing bolt (C)
6. Guide roller
6
5
1. Bit
1
2. Guide roller
3. Workpiece
2
1. Vacuum hose
1
2. Vacuum cleaner
2
1. Screwdriver
2. Screw
3. Hole
4. Vacuum hose
5. Router base
5
1
5
006288
Connect another and of the hose to the vacuum cleaner
hose of 38 mm in inner diameter using a joint.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the rear cover.
005049
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
7
1. Hose
2. Joint
2
3
3. Vacuum hose
4. Outer diameter
φ32 mm
5. Inner diameter
4
φ38 mm
1. Limit mark
1
1. Screwdriver
2. Rear cover
1
2