Makita 3612 사용 설명서 - 페이지 10

{카테고리_이름} Makita 3612에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3612 20 페이지. Guide rail adaptor
Makita 3612에 대해서도 마찬가지입니다: 부품 분석 (3 페이지), 사용 설명서 (16 페이지)

페이지 인쇄

1. Bit

2. Base

3. Templet

4. Workpiece

5. Distance (X)

6. Outside diameter of the templet

guide

7. Templet guide

1. Wing bolt (A)

2. Guide holder

3. Fine adjusting screw

4. Wing bolt (B)

5. Wing bolt (C)

6. Trimmer guide

7. Guide roller

Secure the templet to the workpiece. Place the tool on the templet and move

003695

the tool with the templet guide sliding along the side of the templet.

NOTE:

•

The workpiece will be cut a slightly different size from the templet. Allow

for the distance (X) between the bit and the outside of the templet guide.

The distance (X) can be calculated by using the following equation:

Distance (X) = (outside diameter of the templet guide - bit diameter) / 2

Trimmer guide (optional accessory)

003698

Trimming, curved cuts in veneers for furniture and the like can be done easily

with the trimmer guide. The guide roller rides the curve and assures a fine cut.

Install the trimmer guide on the guide holder with the wing bolt (B). Insert the

003700

guide holder into the holes in the tool base and tighten the wing bolt (A). To

adjust the distance between the bit and the trimmer guide, loosen the wing bolt

(B) and turn the fine adjusting screw (1.5 mm per turn). When adjusting the

guide roller up or down, loosen the wing bolt (C). After adjusting, tighten all the

wing bolts securely.