Garage Smart Hard Top Lifter 사용자 설명서 - 페이지 12
{카테고리_이름} Garage Smart Hard Top Lifter에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garage Smart Hard Top Lifter 20 페이지.
페이지 인쇄- 1. Table of Contents
- 2. Safety Information/About Hardtop Lifter
- 3. Product Identifier
- 4. What's in the Box
- 5. Hardtop Lifter Installation Tools and Notes
- 5. Step 1: Smarttrack
- 5. Smarttrack Troubleshooting
- 5. Step 2: Assembly - Length Adjuster
- 5. STEPS 3 & 4: ASSEMBLY - WIDTH ADJUSTER and FOAM BLOCKS
- 5. Step 5: Assembly - Pulley Slider
- 5. Step 6: Assembly - Vehicle Installation
- 5. Step 7: Assembly - Cargo Net and Configuration
- 5. Step 8: Assembly - Adjustments
- 6. Faqs
- 7. Warranty
10
HARDTOP LIFTER INSTALLATION
5. Pulley Sliders
1. Set the pulley sliders (I) at equal positions anywhere along the
groove of the length adjusters and secure them with the short
quick-release pins (G).
NOTE
A good starting point for the common 4-door Jeep top is to
place the short pins through the back of the pulley frame (I)
and the 14
th
hole from the back of the length adjuster (A).
2. Also place short pins in the last hole of each length adjuster,
even if it passes through the pulley holder again.
While 8 pins are provided, they may not all be necessary for
some configurations. (Fig 5.2)
3. Place the frame under the myLifters and extend the myLifter
cables long enough to reach the floor and up again.
CAUTION
For V1 lifters, be sure to keep weight on the cable as it extends.
4. Pass each cable through the appropriate pulley frame. One
cable should pass through one frame under both pulleys. Hook
the cable eyelet with the carabiner to the track. (Fig 5.4)
ASSEMBLY
Fig 5.2
Fig 5.4