IKEA UTSUND 매뉴얼 - 페이지 5
{카테고리_이름} IKEA UTSUND에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA UTSUND 16 페이지.
IKEA UTSUND에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지)
ENGLISH
Guidance for Seasonal and Holiday
lighting sets.
Follow these and any other instruc-
tion provided by the manufacturer, it
is for your safety.
1. Install the lighting chains so that
there is easy access to the socket-out-
let so that the lights can be turned off
when you go out or go to bed. Never
leave lighting chains on when you go
out or go to bed.
2. Do not remove or insert lamps
while the lighting chain is connected
to the supply.
3. For series-connected lamps other
than those in sealed lighting chains,
replace failed lamps immediately by
lamps of the same rated voltage and
wattage to prevent overheating; this
requirement does not apply to sealed
lighting chains.
4. Do not connect the chain to the
supply while it is in the packing.
5. For series-connected lamps where
fused lamps are used, do not replace
a fused lamp with a non-fused lamp.
6. Ensure all lampholders are fitted
with a lamp.
7. Ordinary lighting chains marked for
indoor use shall not be used out-
doors.
8. Lighting chains which rely on
gaskets to provide protection against
ingress of dust and moisture must not
be used without all gaskets being in
place.
9. Make sure to follow the markings
regarding series and parallel connec-
tion of lighting strings.
10. Only replace 'fused' lamps (some-
times identified by a white mark
on the glass) with identical 'fused'
lamps.
11. For non-standard lamps (e.g.
lamps of push-in type) replacement
lamps must be of the same types as
those delivered originally or a type
specified by the manufacturer.
12. Do not attempt to replace non-re-
placeable lamps.
ENGLISH
This device complies with part 15 of
the FCC Rules. Operation is subjected
to the following two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any in-
terference received, including inter-
ference that may cause undesired
operation.
WARNING
Changes or modifications not ex-
pressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
SAVE THESE
INSTRUCTIONS
5