Makita 3706 사용 설명서 - 페이지 8

{카테고리_이름} Makita 3706에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3706 17 페이지. Cutout tool
Makita 3706에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지), 사용 설명서 (10 페이지), 부품 설명서 (2 페이지), 사용 설명서 (13 페이지), 사용 설명서 (12 페이지)

페이지 인쇄

OPERATION

1. Shoe

2. Loosen

3. Tighten

4. Thumb screw

When inserting the drywall guide bit into the drywall, care-

001629

fully insert the bit straight until the shoe base is in full contact

with the material.

Move the tool slowly with a constant pressure in a clockwise

direction to make the cut.

When cutting straight line, clamp a straight board firmly to

001630

the material and use it as a guide. Move the tool in the direc-

tion of the arrow with the shoe base flush with the side of the

guide board.

When the cut is complete, turn the tool off and wait for the bit

to stop rotating and then carefully remove it from the mate-

rial.

NOTE:

1. When using this tool, the rotating action causes the tool

to pull. The less pressure applied to the tool causes less

pull and provides a more accurate cut. Excessive pres-

sure or fast cutting can cause the bit to dull or break pre-

mature.

2. When cutting drywall around outlet boxes, cut in a coun-

terclockwise direction for ease of cut.

3. The standard bit included with this tool is for cutting dry-

wall only. When cutting materials other than drywall, do

not use the standard drywall guide bit.

Circular guide

Circular cutting diameters: 10 cm (4") - 34 cm (13-3/8")

Installing circular guide

001631

Release the thumb screw which serves to secure the shoe.