Makita 3707 사용 설명서 - 페이지 8

{카테고리_이름} Makita 3707에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3707 13 페이지. Trimmer
Makita 3707에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (16 페이지), 사용 설명서 (10 페이지)

페이지 인쇄

001712

Trimmer guide

001713

Trimming, curved cuts in veneers for furniture and the

like can be done easily with the trimmer guide. The guide

roller rides the curve and assures a fine cut.

Install the trimmer guide on the tool base with the clamp

screw (A). Loosen the clamp screw (B) and adjust the

distance between the bit and the trimmer guide by

turning the adjusting screw (1 mm per turn). At the

desired distance, tighten the clamp screw (B) to secure

the trimmer guide in place.

001714

When cutting, move the tool with the guide roller riding

the side of the workpiece.

001998

1. Nail

2. Center hole

3. Straight guide

1. Adjusting screw

2. Clamp screw (B)

3. Trimmer guide

4. Clamp screw (A)

1. Workpiece

2. Bit

3. Guide roller

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or the

•

like. Discoloration, deformation or cracks may

result.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take

out the worn carbon brushes, insert the new ones and

secure the brush holder caps.

001999

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers, always

using Makita replacement parts.

1. Limit mark

1. Screwdriver

2. Brush holder

cap