CORNING LSE 6709 사용 설명서 - 페이지 8
{카테고리_이름} CORNING LSE 6709에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING LSE 6709 12 페이지. Digital vortexer
CORNING LSE 6709에 대해서도 마찬가지입니다: 사용 설명서 (9 페이지)
Power
RPM signal light is on. By rotating the encoder knob right (+) or left (-) the desired RPM can
be selected:
34 = 340 rpm
•
120 = 1,200 rpm
•
Press the Start/Stop button to start operation.
Power
Run and Time signal lights are on. The vortexer runs and counts down the time from the
set value.
NOTE: You cannot modify the set time during vortexing. However, you can stop the unit with
the Start/Stop button and then reset the time.
Power
If you want to change the RPM during vortexing, push the encoder knob to put the vortexer
into RPM set mode (RPM signal light will be on). Rotate the encoder knob right (+) or left
(-) to set the desired value. In the meantime RPM signal light will flash. When you stop
rotating the encoder knob, the signal light for RPM will stop flashing after 2 seconds.
6
CO R N I N G L S E D I G I TA L VO RT E X E R
Run
Time
Speed
Speed(RPMx10) Time (min)
Run
Time
Speed
Speed(RPMx10) Time (min)
Run
Time
Speed
Speed(RPMx10) Time (min)
Start
ENCODER
Stop
PUSH
(Time/Speed)
Start
ENCODER
Stop
PUSH
(Time/Speed)
Start
ENCODER
Stop
PUSH
(Time/Speed)