CORNING LSE 6710 사용 설명서 - 페이지 6
{카테고리_이름} CORNING LSE 6710에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING LSE 6710 9 페이지. Digital vortexer
CORNING LSE 6710에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)
페이지 인쇄Run
Time
Power
Speed (RPMx10) time (min)
If you want to change the RPM during vortexing, push the encoder knob to put the
◗ ◗
Vortexer into RPM set mode (RPM signal light will be on). Rotate the encoder right (+)
or left (-) to set the desired value. In the meantime RPM signal light will flash. When
you stop rotating the encoder knob, the signal light for RPM will stop flashing after 2
seconds.
Run
Time
Power
Speed (RPMx10) time (min)
When the run time has elapsed or when you press the START/STOP button, the display
◗ ◗
will show "End" and the RUN light will flash. When the Vortexer completely stops the
set speed and time will return to the last programmed values.
10
C ORNING LS E MU LTI PU R PO S E D I G I TA L VO RTEXER
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
5.3. Additional Operations
Run
Time
Power
Speed (RPMx10) time (min)
If you want to view the set value for RPM during vortexing, rotate the encoder knob
◗ ◗
for ONE CLICK right (+) or left (-). The RPM signal light will flash for 2 seconds and the
display will show the set RPM. After 2 seconds the RPM and the signal light will stop
flashing.
NOTE: The Vortexer must be in RPM mode – RPM signal light must be on.
Run
Time
Power
Speed (RPMx10) time (min)
If you want to view the set value for TIME during vortexing, rotate the encoder ONE
◗ ◗
CLICK right (+) or left (-). The TIME signal light will flash for 2 seconds, and the display
will show the set TIME. After 2 seconds the display will return to the count TIME, and
the signal light will stop flashing.
NOTE: The Vortexer must be in the TIME mode – the TIME signal light must be on.
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Instruction Manual
11