CORNING LSE 6765-HS 사용 설명서 - 페이지 10

{카테고리_이름} CORNING LSE 6765-HS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING LSE 6765-HS 16 페이지. High speed microcentrifuge



Corning

LSE

Figure 2.

5. Service and Maintenance

5.1 Centrifuge service

The brushless motor in the Corning

requires no routine maintenance. Any required service should be performed by

authorized, qualified personnel only. Repairs performed by unauthorized

personnel may void the warranty.

5.2 Cleaning the centrifuge

Always keep the centrifuge housing, rotor chamber, rotor and rotor accessories

clean. All parts should be wiped down periodically with a soft cloth. For more

thorough cleaning, use a neutral cleaning agent (pH between 6 and 8) applied

with a soft cloth. Excessive amounts of liquid should be avoided. Liquid should

not come into contact with the motor. After cleaning, ensure that all parts are

dried thoroughly by hand or in a warm air cabinet (maximum temperature 50ºC).

5.3 Cleaning the rotor

The rotor should be cleaned after each use. When spinning samples containing

phenol or phenol chloroform, the rotor should be cleaned immediately after use.

Should a spill of infectious materials occur within the rotor or chamber, the unit

should be disinfected. This should be performed by qualified personnel with

proper protective equipment.

Check the fuse when it is recommended in the Troubleshooting Guide located

in this manual. The fuse holder is located in the power inlet on the rear of the

unit. Disconnect the power cord from the power inlet. Open the fuse holder

drawer by inserting a small screwdriver under the tab and prying it open.

Remove the innermost (operative) fuse from its retaining tabs and replace the

fuse if necessary. A spare fuse is located in the outermost chamber of the fuse

drawer. Replace only with a fuse of exactly the same value as the original.

(Fuse type may be found in the Technical data section of this manual.)

High Speed Microcentrifuge control panel layout



LSE High Speed Microcentrifuge