Makita 3708 사용 설명서 - 페이지 7
{카테고리_이름} Makita 3708에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3708 16 페이지. Trimmer
Makita 3708에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
2
1
001985
CAUTION:
Since excessive cutting may cause overload of the
•
motor or difficulty in controlling the tool, the depth of
cut should not be more than 3 mm at a pass when
cutting grooves. When you wish to cut grooves
more than 3 mm deep, make several passes with
progressively deeper bit settings.
Templet guide
001986
The templet guide provides a sleeve through which the
bit passes, allowing use of the trimmer with templet
patterns.
Remove the tool base from the tool. Loosen the wing
bolts and secure the tool base horizontally. Loosen the
two screws on the tool base.
1
2
002006
Place the templet guide on the tool base. There are four
convex portions on the templet guide. Secure two of the
four convex portions using the two screws. Install the tool
base on the tool.
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
1. Base
3
2. Wing bolt
3. Screws
4. Screwdriver
4
1
002007
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
10mm (3/8")
001988
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of the templet guide -
router bit diameter) / 2
Straight guide (optional accessory)
001989
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Attach the guide plate to the straight guide with the bolt,
the wave washer, the flat washer and the wing nut.
7
1. Templet guide
2. Convex portions
2
1. Straight bit
6
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
5