Garage Tek GT1005A 설치 및 사용 설명서 - 페이지 4

{카테고리_이름} Garage Tek GT1005A에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garage Tek GT1005A 4 페이지. Wall cabinet

INSTALL DOOR BIN, SHELVES AND LOGO

SNAP THE DOOR BIN (J) IN THE TRACKS ON THE INSIDE OF THE DOOR.

SNAP THE SHELF HOLDER STRIPS (i) X8 , INTO THE VERTICAL TACKS AROUND THE INSIDE OF THE CABINET. THERE ARE

X4 STRIPS PER LOCATION. THE STRIPS WITH THE ARCHED HOOD ARE IN THE BACK OF THE CABINET AND THE FLAT

TOPPED STRIPS ARE ON THE SIDES.

PLACE THE SHELVES (C) X2, ON THE STRIP HOLDER STRIPS (i).

APPLY THE GT LOGO (P), X1, ON THE LOCATION SHOWN.

INSTALL HANDLE SET

A. ORIENTATE THE HANDLE SET (G) AS SHOWN WITH THE PACKLOCK HOLES IN-LINE ON EACH HANDLE AND ARE AT THE

BOTTOM OF THE HANDLE SET.

B. DO NOT USE A POWER TOOL. HAND SCREW AND SECURE THE HANDLE WITH A 1 1/2" SCREW (H) & 7/8" LONG SCREW

(K) PER SIDE SIDE.

C. ADJUST THE HANDLES TO BE IN-LINE AND LEVEL BY LOOSENING AND RETIGHTENING THE SCREWS AS NEEDED.

ADDITIONAL SHELVES (C) CAN BE PURCHASED AS P/N: GT1007.

PADLOCK

HOLES

PAGE 4 OF 4 REV AUG 2021