CORNING LSE Low Speed Orbital Shaker 사용 설명서 - 페이지 4
{카테고리_이름} CORNING LSE Low Speed Orbital Shaker에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING LSE Low Speed Orbital Shaker 10 페이지.
페이지 인쇄
1.0 GENERAL SPECIFICATIONS
Electrical requirements:
115V model
230V model
Fuse
Speed
Shaker Orbit
Timer
Maximum Load
Dimensions WxLxH
Platfrom dimensions WxL
Weight
Operating Conditions
2.0 INSTALLATION OF THE SHAKER
2.1 UNPACKING
Before starting the installation, carefully examine the shaker for possible damage or missing parts.
Open the box and carefully remove the padding. Check that the shaker has not been visibly
damaged during transportation.
Keep the packing material until you are sure that the shaker works properly.
Carefully lift the device out of the box.
Be sure that the following information is included on the serial label located on the back of the
unit: Serial Number, Product Number, Electrical Rating.
Check that the power cord has a pin configuration that fits into a wall socket according to the
local standard.
Should any kind of damage have occurred during transportation, contact Corning Customer Service or
the Corning dealer the product was purchased from as soon as possible to file a claim with the carrier.
2.2 SELECTING THE CORRECT LOCATION
When locating the shaker, please consider following:
Put the shaker on horizontal, leveled and stable surface.
Leave enough space around the shaker for normal air circulation, minimally 10 cm.
Leave enough space around the shaker for easy access and maintenance.
Avoid locations subject to shocks and vibrations.
Avoid locations subject to frequent power fluctuations or power losses (this may affect shaker
performance).
Note: There has to be an easy access to the shaker control panel and main plug in case of emergency.
2.3 ATTACHING THE POWER CORD
First connect the main power cord to the shaker then connect the plug end of the cord to a grounded wall
socket. Avoid lines on which powerful electric motors, refrigerators and similar devices are connected.
Be careful when you plug the cord to a grounded wall socket!
Do not touch plug with wet hand!
Do not pull the plug by the cord!
115V 10% - 50/60Hz, 0.3A
230V 10% - 50/60Hz, 0.15A
2 x 0.5A 230V; 2 x 1A 115V
from 3 to 60 rpm
19 mm (0.75 inch)
20 – 120 minutes in 10 minute step, HOLD function
5 kg
295 x 340 x160 mm
295 x 295 mm useable area
6.6 kg
4°C to 70°C, up to 85% RH, non-condensing
1