ALIBI ALI-NS4002R 빠른 설치 매뉴얼 - 페이지 3

{카테고리_이름} ALIBI ALI-NS4002R에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIBI ALI-NS4002R 6 페이지. 2 mp ip bullet camera

페이지 인쇄

Selected

Activate

Click the Activate button. In the Activate window, you will create a password for the admin

(administrator) username.

In the Activate window, enter an a password for admin in the New Password field. Include a

combination of uppercase, lowercase alphabetic characters and numbers to create a "Strong"

password. The rating is shown beneath the Password field. See above.

Enter the admin password again in the Confirm field, and then click Activate. In the screen

below, notice that the device Security status shows "Active". Record your admin password for

reference later.

If you lose your admin (administrator) password, you cannot configure the device or restore



it to its factory settings. To reset your password, call your support organization for specific

CAUTION

instructions.

Notice that although the device is now activated, it retained the default IP address.

Step 6.

Edit Network Parameters

NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.

The camera will receive network configuration settings from the NVR. Refer to the documentation available

for your NVR firmware for more information.

You can change the network parameters of devices that are active.

In the list of devices discovered, click on the device you want to change the network settings for, and

then click the select box to check it. See below.

Edit Network Parameters

In the popup window, edit the current network parameters, and then enter the Administrator

(admin) user password in the field at the bottom.

Enable DHCP: You can select Enable DHCP to acquire compatible network settings from

a DHCP server installed on the LAN. However, these settings might be changed later by the

DHCP server. Since it is recommended to use an unchanging IP address, you can use DHCP

to acquire compatible network settings, and then uncheck Enable DHCP and save that

configuration to retain the new network parameters.

www.observint.com

In the example below, Enable DHCP was checked to acquire compatible network settings

from the DHCP server.

Click OK to save your settings. The parameter change(s) will be shown device's network parameters

(see below).

Step 7.

NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.

Microsoft® IE is used to access your camera remotely. IE must run as an Administrator to use all features

available through a remote login to the camera.

Setting MS Internet Explorer to run as an Administrator

Window 7: To run IE as an Administrator:

Find or create an IE icon on your computer desktop.

Hold down the shift key, and then right-click on the IE icon.

MS Internet

Explorer icon

Click Run as administrator in the pop-up menu.

Window 10: To run IE as an Administrator:

Find MS IE in the start menu. Usually this is found in the Windows Accessories group.

Pin the entry to Start.

Right click on the Internet Explorer tile, and then select More | Run as administrator.

Run as administrator