CORNING PC-600D 사용 설명서 - 페이지 6

{카테고리_이름} CORNING PC-600D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING PC-600D 14 페이지. Digital hot plates, stirring hot plates, stirrers, and external temperature controller
CORNING PC-600D에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 사용 설명서 (8 페이지), 사용 설명서 (14 페이지)

페이지 인쇄

5. When desired stirring is complete, turn the Stir Control Knob to the OFF position. Allow stir

bar to cease rotation before removing the vessel from the unit.

6. Heating and stirring can be performed simultaneously with the PC-420D and PC-620D

models, which offer both heating and stirring functions.

NOTE: The viscosity of the stirred material will affect the ability of the stir bar to remain

coupled to the rotating ring magnet. Materials of high viscosity must be stirred at slower

speed settings.

6.0 Heating Instructions

Without the External Temperature Controller for Models: PC-400D, PC-420D, PC-600D,

and PC-620D

1. Fill the vessel with solution to be heated.

2. If using a PC-420D or PC-620D model and the stirring function, place the stir bar into

the vessel.

3. Place vessel in the center of the top surface.

4. Turn Heat Control Knob until the Heating Temperature Display shows the desired

temperature. The temperature setting can be adjusted in 5°C increments.

Flashing Display: The number shown on the Heating Temperature Display will FLASH

when the actual heating temperature is not at the set temperature.

Constant Display: The number shown on the Heating Temperature Display will remain

constantly ON when the actual heating temperature is at the set temperature.

Hot Top Indicator: The Hot Top Indicator will be ON at all times when the temperature

of the top surface is too hot to touch (greater than approx. 60°C).

The Hot Top Indicator will FLASH when the Heat Control Knob is turned OFF but the top

surface is still too hot to touch.

The Hot Top Indicator will be OFF when the temperature of the top is less than approx.

60°C.

CAUTION: The Hot Top Indicator will turn OFF when the power cord is

disconnected from the product even if the temperature of the top surface

is still too hot to touch.

With the External Temperature Controller (Corning 6795PR) for Models: PC-400D, PC-420D,

PC-600D, PC-620D, and 6795PR

1. Connect the External Temperature Controller to the connector on the back of the unit.

Temperature Probe in Use Indicator: This will illuminate when the External Temperature

Controller is properly connected.

2. Fill the vessel with solution to be heated.

3. If using a PC-420D or PC-620D model and the stirring function, place the stir bar into

the vessel.

4. Place the vessel in the center of the top surface.

5. Insert the tip of the External Temperature Probe into the solution.

The tip should be located in the center of the vessel and at approximately one-half

of the depth of the solution.

CORNING DIGITAL HOT PLATES, STIRRING HOT PLATES, STIRRERS

AND EXTERNAL TEMPERATURE CONTROLLER